p. 19/40 18 9 10 1 2 3 8 4 7 6 5 English AT928 AT928_EN_A6_CS3.indd 18 13.5.21 1:53:21 PM
p. 20/40 introduction Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips. com/welcome. Please read this user manual, as it contains information about the wonderful features
p. 21/40 This appliance is not intended for use by persons - (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by
p. 22/40 If the shaver is subjected to a major change - in temperature, pressure or humidity, let it acclimatise for 30 minutes before you use it. Electromagnetic fields (EMF) This Philips appliance complies with all applicable - standards and regulations regarding
p. 23/40 Charge indications Battery low - When the battery is almost empty (when there are only 5 or fewer shaving minutes left), the charging light starts to flash orange. When you switch off the shaver, the charging light - continues to flash orange for a few seconds.
p. 24/40 Using the shaver Note: This shaver can be used in the bath or shower. For safety reasons, It can therefore not be used directly from the mains.shaving tips and tricks This shaver is suitable for both wet and dry use. - Use the shaver with shaving gel or
p. 25/40 5 Move the shaving heads in circular movements over your skin. Note: Rinse the shaver under the tap regularly to ensure that it continues to glide smoothly over your skin. 6 After shaving, press the on/off button once to switch off the shaver and dry your
p. 26/40 3 After trimming, press the on/off button once to switch off the shaver. 4 Clean the trimmer (see chapter ‘Cleaning and maintenance’). 5 Close the trimmer (‘click’). Cleaning and maintenance Remove the detachable cord from the handheld part before cleaning
p. 27/40 2 Press the release button to open the shaving unit. 3 Rinse the shaving unit and hair chamber under a hot tap for 30 seconds. Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt. - Rinse the hair
p. 28/40 2 Press the release button to open the shaving unit. 3 Pull the shaving unit off the shaver. 4 Turn the lock anticlockwise (A) and remove the retaining frame (B). 5 Remove and clean one shaving head at a time. Each shaving head consists of a cutter and a
p. 29/40 6 Put the shaving heads back into the shaving unit. Note: Make sure that the projections of the shaving heads fit exactly into the recesses. 7 Put the retaining frame back into the shaving unit (A) and turn the lock clockwise (B). 8 Insert the lug of the
p. 30/40 Tip: For optimal trimming performance, lubricate the trimmer teeth with a drop of sewing machine oil every six months. storage - Put the protection cap on the shaver to prevent damage. Replacement For maximum shaving performance, we advise you to replace
p. 31/40 3 Press the release button to open the shaving unit. 4 Pull the shaving unit off the shaver. 5 Turn the lock anticlockwise (A) and remove the retaining frame (B). 6 Remove the shaving heads and place new ones in the shaving unit. Note: Make sure that the
p. 32/40 9 Press and hold the on/off button for 5 seconds to reset the replacement reminder on the shaver . The orange light goes out. Ordering accessories To buy accessories or spare parts, visit www. shop.philips.com/service or go to your Philips dealer. You can
p. 33/40 point for batteries. If you have trouble removing the battery, you can also take the appliance to a Philips service centre. The staff of this centre will remove the battery for you and will dispose of it in an environmentally safe way. Removing the rechargeable
p. 34/40 guarantee restrictionsThe shaving heads (cutters and guards) are not covered by the terms of the international guarantee because they are subject to wear. Troubleshooting This chapter summarises the most common problems you could encounter with the appliance.
p. 35/40 Problem Possible cause Solution The shaver does not work when I press the on/off button. The rechargeable battery is empty. Recharge the battery (see chapter ‘Charging’). The temperature of the shaver is too high. In this case, the shaver does not work.